CAM_RESRC_UNAVAIL - some resource is temporarily unavailable and the SIM driver cannot generate an event when it will become available. An example of this resource would be some intra-controller hardware resource for which the controller does not generate an interrupt when it becomes available.

CAM_UNCOR_PARITY - unrecovered parity error occurred

CAM_DATA_RUN_ERR - data overrun or unexpected data phase (going in other direction than specified in CAM_DIR_MASK) or odd transfer length for wide transfer

CAM_SEL_TIMEOUT - selection timeout occurred (target does not respond)

CAM_CMD_TIMEOUT - command timeout occurred (the timeout function ran)

CAM_SCSI_STATUS_ERROR - the device returned error

CAM_AUTOSENSE_FAIL - the device returned error and the REQUEST SENSE COMMAND failed

CAM_MSG_REJECT_REC - MESSAGE REJECT message was received

CAM_SCSI_BUS_RESET - received SCSI bus reset

CAM_REQ_CMP_ERR - “impossible” SCSI phase occurred or something else as weird or just a generic error if further detail is not available

CAM_UNEXP_BUSFREE - unexpected disconnect occurred

CAM_BDR_SENT - BUS DEVICE RESET message was sent to the target

CAM_UNREC_HBA_ERROR - unrecoverable Host Bus Adapter Error

CAM_REQ_TOO_BIG - the request was too large for this controller

CAM_REQUEUE_REQ - this request should be re-queued to preserve transaction ordering. This typically occurs when the SIM recognizes an error that should freeze the queue and must place other queued requests for the target at the sim level back into the XPT queue. Typical cases of such errors are selection timeouts, command timeouts and other like conditions. In such cases the troublesome command returns the status indicating the error, the and the other commands which have not be sent to the bus yet get re-queued.

CAM_LUN_INVALID - the LUN ID in the request is not supported by the SCSI controller

CAM_TID_INVALID - the target ID in the request is not supported by the SCSI controller